1. Hold the printer by the front, and firmly lift the DK Roll Compartment Cover to open it.
     
  2. Place the DK Roll into the Roll Spool Guide.
    • Make sure that the Roll Spool Arm (1) is inserted firmly in the Roll Spool Guide (2).
    • Make sure that the Stabilizer (3) slides into the notch of the printer.
  3. Thread the DK Roll through the printer.
    • Align the edge of the DK Roll with the upright edge of the Label Output Slot.
    • Insert the first label into the slot inside the compartment.
    • Push the label through the Label Output Slot until the end reaches the mark, as shown.
  4. Close the DK Roll Compartment Cover.
    When you press the Power (Power button) Button to turn the printer On, the end of the DK Roll aligns automatically.